Mc-leod 1970-1981 Camaro Hydraulic Conversion Instructions Bedienungsanleitung PDF herunterladen

1970 – 81 Chevrolet Camaro Hydraulic Clutch Conversion Kit

1) Remove all of the existing factory mechanical clutch linkage components. (Clutch rod, bell crank or

Z bar) from under the dash and at the bell housing area.

Figure 1 Figure 2

2) Remove the brake master cylinder and booster assembly (if equipped). Carefully remove the

brake lines from the master cylinder and mark them to be certain they are reinstalled into the

correct ports. Brake lines may need to be rerouted if interference occurs. Only use proper steel

brake lines when rerouting the brake lines.

3) Remove heavy pedal return spring if present. Disassemble the pedals from the pedal box. Note

order of all parts (spacers, washers, nylon washers, pivot sleeve, etc) during disassembly. The

pivot rod at the top of the box is secured with a bolt and nut. Remove the bolt and nut and slide the

bolt out of the box.

4) The clutch pedal must be drilled to relocate the position of the push rod. Figure 3. Using the

supplied card board guide, place the guide on the left side of the pedal. Fig 4 Punch the pedal at

the indicated location and drill a 3/8” hole through the pedal. Debur the new hole, lube the

components and reassemble the pedals to the upper pedal box securing with the bolt and nut

removed in step 3.

Figure 3 Figure 4

1 2

Seite 1

1970 – 81 Chevrolet Camaro Hydraulic Clutch Conversion Kit 1) Remove all of the existing factory mechanical clutch linkage components. (Clutch rod,

Seite 2

5) Both pedals should now be securely mounted and travel through their complete arc. Be sure to install the rubber pedal covers at this time. See Fi

Keine Kommentare

Mc-leod 1970-1981 Camaro Hydraulic Conversion Instructions Bedienungsanleitung